Palawan EVT to DVT changes

From Studio Kousagi Wiki
Revision as of 05:43, 23 December 2015 by Xobs (talk | contribs) (Palawan Rx Board changes)
Jump to: navigation, search

Palawan Rx Board changes

ECO1: Swap D11U pins

The diode D11U footprint and schematic pins are swapped. Correct this.


ECO2: Send USB pullups to VPP

The USB pullups on USBDN_RST and USBDP_LED are going to VUSB. They should instead go to VPP, otherwise USB will fail to function.


ECO3: Populate R15U with 1.5k, 10%

Enable low-speed USB operation by populating R15U with a 1.5k, 1% resistor.


ECO4: Make debug pins oval

The debug pins on the side should be made oval, for easier soldering


ECO5: Add GND, VPP debug pins

To make life easier, add pins for probing GND and VPP.