Difference between revisions of "Palawan DVT"

From Studio Kousagi Wiki
Jump to: navigation, search
Line 12: Line 12:
  
 
*ECO1*: There is a stray via on the board.  Run DRC prior to exporting to gerbers to repour copper.
 
*ECO1*: There is a stray via on the board.  Run DRC prior to exporting to gerbers to repour copper.
*ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt.  Move DIO0 to PTA10, PTA11, or PTA12.
+
*ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt.  Move DIO0 to PTA12.

Revision as of 05:32, 10 June 2017

Palawan DVT represents a complete redesign. The main MCU has changed, and we now use a SoM for the radio.

Palawan Rx ECOs

  • ECO1*: The LED is backwards, and should be flipped around.
  • ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12.
  • ECO3*: There is a ground (and power) plane directly under the RFM69HW. This should be pulled back.
  • EC04*: The LP3982 footprint has no "Pin 1" marker. Add a Pin 1 marker.
  • ECO5*: The KL02 footprint has a non-obvious "Pin 1" marker. Make it clearer.

Palawan Tx ECOs

  • ECO1*: There is a stray via on the board. Run DRC prior to exporting to gerbers to repour copper.
  • ECO2*: RFM69HW DIO0 is connected to a pin that cannot generate an interrupt. Move DIO0 to PTA12.