Topic: Problem detecting input resolution
I received the NeTV starter kit sometime ago and I followed the steps on the wiki to update the firmware and assemble the product.
However, plugging it into the TV, I get a message saying 'Problem detecting input resolution' and it is followed by a blank screen(or the STB content if I plug in the STB as input). It occasionally switches to the WiFi configuration screen of NeTV but the duration is too short to be able to do anything.
I looked up in the forums to see if there was a fix and I came across this thread.
I'm facing the exact same problem as mcisar and I'm able to replicate all his results[outputs to the various commands] too.
Apart from this, I'm also unable to configure the WiFi through the command line. I get an error which says something along the lines of 'Read-only filesystem' when I execute the commands to configure the WiFi from ubuntu terminal.
Any help/advice would be appreciated.