• bunnie
  • Administrator
  • Offline
  • From: Singapore
  • Registered: 2014-05-25
  • Posts: 56

Topic: ECO for Senoko PVT

ECO for Senoko PVT are listed here:

http://www.kosagi.com/w/index.php?title … T_ECO_List

Minor changes are being introduced to improve routing inside the case, improve mechanical robustness, and address EOL issues.

The list at the time of posting is incomplete; but keep an eye out for a small notch being added to the PVT board for a rib that helps support the screen when it's closed, stripping out the JTAG header (we've never had to use it) to make space, and fixing an EOL issue on the secondary protection circuit and replacing it with a more sophisticated system that hard-cuts the battery even when the MCU is hung.

bunnie's Website

  • bunnie
  • Administrator
  • Offline
  • From: Singapore
  • Registered: 2014-05-25
  • Posts: 56

Re: ECO for Senoko PVT

Senoko PVT ECO list is now near-final, fwiw.

bunnie's Website

  • Registered: 2014-05-30
  • Posts: 191

Re: ECO for Senoko PVT

Any hint when the final list, schematics and source are available?

  • bunnie
  • Administrator
  • Offline
  • From: Singapore
  • Registered: 2014-05-25
  • Posts: 56

Re: ECO for Senoko PVT

Sorry, I forgot to post the design sources. They are up now:

http://www.kosagi.com/w/index.php?title … tery_board

bunnie's Website

  • Registered: 2014-08-08
  • Posts: 12

Re: ECO for Senoko PVT

I think there is a typo in the BOM on line 20. Part L200B in the schematics has the same typo. I haven't checked STEP 3D and Gerbers
XAL7030-322MEC is supposed to be XAL7030-332MEC?

  • bunnie
  • Administrator
  • Offline
  • From: Singapore
  • Registered: 2014-05-25
  • Posts: 56

Re: ECO for Senoko PVT

Good catch. Yes, it should be XAL7030-332MEC. thanks!

bunnie's Website