Re: 3D print - CPU fan duct

GregRob wrote:

I've made another 3D printable object for my Novena.  It is a fan duct that mounts beside the CPU (over the SD card holder) and blows air through the CPU heat sink.  It is on thingverse: http://www.thingiverse.com/thing:763391

Thanks for sharing, works fine! A bit noisy but as you said using GPIO-fan should limit that. I also let it build via Shapeways, just one week and everything was ready.
https://lh3.googleusercontent.com/-XjXnw6Zjdi0/WMq92LJU0BI/AAAAAAAAAM8/Rh_hXQXUnHYziPPKMFQPKY69KIytgwGjgCL0B/w530-d-h398-p/novena_fan.jpg
https://lh3.googleusercontent.com/-Ab1cT4SFClY/WMq9-xyslwI/AAAAAAAAANU/ctDrNS6GnJYtqWc_wVvxO5l0V-jz1vyOQCL0B/w363-d-h327-p/screenshot-20170316-171746.png