1

(112 replies, posted in Hardware)

See logs below:

Waiting for serial port to connect: .....
Setting serial port parameters... Ok
Initiating communication... Ok
Getting hardware version... 0xcb01
Getting chip ID... 0x6261
Getting boot config (low)... 0x0000
Getting boot config (high)... 0x0000
Getting hardware subcode... 0x8000
Getting hardware version (again)... 0xcb01
Getting chip firmware version... 0x0001
Getting security version... v 5
Enabling security (?!)... Ok
Reading ME... 00000000 80 88 80 f4 f4 1b da 78  a4 a6 cf ad 34 80 cd 3f  |.......x....4..?|
Disabling WDT... Ok
Reading RTC Baseband Power Up (0xa0710000)... 0x0002
Reading RTC Power Key 1 (0xa0710050)... 0xa357
Reading RTC Power Key 2 (0xa0710054)... 0x67d2
Setting seconds... Ok
Disabling alarm IRQs... Ok
Disabling RTC IRQ interval... Ok
Enabling transfers from core to RTC... Ok
Reading RTC Baseband Power Up (0xa0710000)... 0x0002
Getting security configuration... None.
Getting PSRAM mapping... 0x0000
Disabling PSRAM -> ROM remapping... Ok
Checking PSRAM mapping... 0x0002
Checking on PSRAM mapping again... 0x0002
Updating PSRAM mapping again for some reason... Ok
Reading some fuses... 0x00000000
Enabling UART... 0x0000
Loading Fernly USB loader... !! First response is 0x1d12, not 0 !!

Do I have to change the UART speeds?there set to 115200 right now..

2

(112 replies, posted in Hardware)

Hi,

I recently got a DZ09 for christmas, and looking at customizing/creating/and flashing firmware. However I was wondering where do I start? I tried using fernvale but it stopped at one of the last steps.