Difference between revisions of "Palawan EVT to DVT changes"
(→Palawan Rx Board changes) |
(→Palawan Rx Board changes) |
||
Line 15: | Line 15: | ||
Enable low-speed USB operation by populating R15U with a 1.5k, 1% resistor. | Enable low-speed USB operation by populating R15U with a 1.5k, 1% resistor. | ||
+ | |||
+ | |||
+ | ===ECO4: Make debug pins oval=== | ||
+ | |||
+ | The debug pins on the side should be made oval, for easier soldering | ||
+ | |||
+ | |||
+ | ===ECO5: Add GND, VPP debug pins=== | ||
+ | |||
+ | To make life easier, add pins for probing GND and VPP. |
Revision as of 05:43, 23 December 2015
Contents
Palawan Rx Board changes
ECO1: Swap D11U pins
The diode D11U footprint and schematic pins are swapped. Correct this.
ECO2: Send USB pullups to VPP
The USB pullups on USBDN_RST and USBDP_LED are going to VUSB. They should instead go to VPP, otherwise USB will fail to function.
ECO3: Populate R15U with 1.5k, 10%
Enable low-speed USB operation by populating R15U with a 1.5k, 1% resistor.
ECO4: Make debug pins oval
The debug pins on the side should be made oval, for easier soldering
ECO5: Add GND, VPP debug pins
To make life easier, add pins for probing GND and VPP.