Difference between revisions of "Novena power characterization"

From Studio Kousagi Wiki
Jump to: navigation, search
Line 27: Line 27:
 
|-
 
|-
 
| 100 || USB downstream hub, USB Ethernet ||  
 
| 100 || USB downstream hub, USB Ethernet ||  
 +
|-
 +
| 100 || USB downstream hub, USB Ethernet, FPGA DRAM ||
 
|}
 
|}

Revision as of 10:46, 29 July 2014

A power draw of 106 mA @ 12V was observed on multiple boards during suspend. Other i.MX6 boards report much lower current consumption, for example 40 mA @ 5V. In order to determine the sources of current drain, components are selectively depopulated and current draw is measured.

For this test, components are removed and then the board is booted. The board is running linux-3.16-rc4. The serial port is set as a wakeup source, although the difference in current draw is negligible when the serial port is not set as a wakeup source, or when the serial cable is detached.

The shell script that performe the suspend is as follows:

#!/bin/sh
echo enabled > /sys/devices/soc0/soc/2100000.aips-bus/21e8000.serial/tty/ttymxc1/power/wakeup
echo mem > /sys/power/state 

The board is awakened by sending any character out the debug serial port

Current draw
Current (mA @ 12V) Component removed Notes
106 None Board fails the factory test -- USB Loopback Test failed.
96 DDR3 Board will not function. Unlike other components, DDR3 module was replaced after the test.
100 PCIe wifi
100 USB downstream hub
100 USB downstream hub, USB Ethernet
100 USB downstream hub, USB Ethernet, FPGA DRAM